Bearing block with two R8 bearings for a 1/2in shaft. The bearing block matches the P7 gearboxes height and width as well as mounting pattern.
In addation to normal uses for a bearing block, this block can be used as an input block for any P7 gearbox.
In addation to normal uses for a bearing block, this block can be used as an input block for any P7 gearbox.
- For Shaft:
- 1/2in
- Material:
- Aluminum
- Height:
- 1-3/4in
- Width:
- 1-3/4in
- Finish:
- Tumbled
- Mounting Holes:
- 4 Total - #10-32 thread
2 on 2 opposing sides
- Bearing(s):
- 2 R8
Click arrow in center of image to load and interact with it