Made of light weight Aluminum, the two piece design allows you to install these collars anywhere on a shaft without removing components. In addition to reducing the overall weight, the flats allow you to rotate a shaft without marring or gouging the shaft. Simply place the collar on the shaft and tighten the two socket-head cap screws to secure the collar and a wrench and be positioned on the collarÂ’s flats to rotate the entire shaft/collar assembly.
This collar is provided as blank so a custom bore can be machined into it. The collar is spot drilled on one side to make drilling/boring easier. Once the bore is machined, the collar can be split by cutting through the groove.
This collar is provided as blank so a custom bore can be machined into it. The collar is spot drilled on one side to make drilling/boring easier. Once the bore is machined, the collar can be split by cutting through the groove.
- Material:
- 6061 AL
- Outside Diameter:
- 1in
- Width:
- 3/8in
- Width Across Flats:
- 7/8in
- Bore:
- Blank
- Weight:
- 0.44oz
- Finish:
- Tumbled
- Screw Size:
- #6-32 x 1/2 in
